![]() USB port working butnot recognising all partitions on all usb flash disks. USB led and lan1 tested and work with programabble settings. I flashed the firmware, it seems to work. * 4 oz cold Coffee an irish coffee mug filled * 1/2 oz Galliano Pour all ingredients into bcm63xx_enetsw bcm63xx_enetsw.0: link DOWN on port1īusyBox v1.19.4 ( 18:24:56 CEST) built-in shell (ash)Įnter 'help' for a list of built-in commands. sd 2:0:0:0: Attached SCSI removable disk sda: p1 size 2049024 extends beyond EOD, truncated sda: p1 size 2049024 extends beyond EOD, enabling native capacity sd 2:0:0:0: Assuming drive cache: write through usb-storage 1-2:1.0: USB Mass Storage device detected usb 1-2: new high-speed USB device number 6 using ehci-platform Note that gpios need to be configured as inputs, to get the state when pressed/released a button. ![]() I'll integrate this stuff in a new build.įor buttons you need to monitor the value (1 or 0) when pressed and released a button, either using the mentioned script or else with gpioctl. ![]() Ok, good job, about WLAN probably the led is controled by the wifi chip itself not a GPIO. I don't know how to test the buttons (wifi, reset, wps). I have checked the voltages on different sections of the router board all seems ok 12v, 5V 3.3V 3V 1.25V, I have tried to backup flash with manual selection /fc:82 the closest one on most of the utilities was S29GL064M, I have attached the bin file I hope if anyone could check it, surprisingly its not empty.I followed theinstructions here for GPIO: I tried Unbufferd Paralled Jtag cable that I had made, USBASP BRJTAG and I have tried many debrick utilities, the cpu is detected BCM6368 but the flash is never detected, I have triple checked the connections but no luck, the flash chip is S29GL064N, I don't know if it's supported by any of the debrick utilities I have tried(Zjtag 1.5-Brjtag 1.9o-Brjtag 2.0.5- Zjtag 1.0-Zjtag 1.8RC3). I restarted the router using the side switch, hoping it will work but it didn't (All LEDs were off) ![]() I have a Huawei HG655B Board, HG655BRZ Ver A, it has been working great since I flashed Firmware HG655b-B025 in 2015, a few days ago it suddenly died, I noticed that All LEDs went off except for the last one to the right (either USB or VOIP) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |